¨      Another innovative design available from J. E. Fifer, is the Positive Overlap Sealer.

¨      A new and innovative method of sealing shrink film on automatic form, fill & seal equipment.

¨      Designed to replace problematic static sealing or erratic drag block or wire systems-the Positive Overlap Sealer is here!

The Overlap Sealer incorporates the following feature:

 ¨      The simple to change heated band, (shown above) makes a strong, and almost invisible longitudinal seal even on the most difficult to wrap packages.

¨      The band has exhibited long life in field use, and its ease of changing minimizes maintenance requirements.

¨      The Sealer is a direct replacement for a static unit or the drag system. Complete with a two-piece mounting plate, the unit is easy to install and service.

¨      A fully self-contained control box allows an easy retrofit without extensive machine wiring changes.

¨      An off-the-shelf Cal 3200 series temperature controller uses PID logic for very accurate temperature control.

FOR MORE INFORMATION:

Contact

J. E. Fifer Sheet Metal Fabricators, Inc.

2301 Old Dominion Street

Richmond, VA. 23224

Tel: 1-800-541-2415

Tel: (804)233-8403

Fax: (804)232-6308